Brands
EPAK 2500 R AMPLIFIER
EPAK 2500 R - The Rack Mounted ES Solution
- - Rack mount version of our popular EPAK2500 Four-way, active control and amplification unit specifically designed for the ES Series modular loudspeaker system
- - Two shock mounted fans move air across the fins but never directly across the electronic components. This minimizes maintenance cycles and improves the components lifespan and reliability
- - Active Driven concept even further with improved sound quality, implementation of VHD technology in our 6MHz or optionally Super Digital 20MHz digital delay line
Features
- - 4-way modular, rack mount 2500W Control and Amplification System for use specifically with ES Series modules.
- - High Frequency, 100W, Class AB, push-pull, low intermodulation amplifier with transformer balanced outputs.
- - Mid Frequency, 200W, Class AB, push-pull, low intermodulation amplifier with transformer balanced outputs.
- - Mid Bass, 600W, high efficiency, current enhancing switching amplifier.
- - Subwoofer, 1600W, high efficiency, current enhancing switching amplifier.
- Complete, on board speaker management system including equalization, time alignment, crossover filters, amplifier overdrive protection, system set-up and output level controls.
- - Newly developed DSD™, 6MHz sampling, digital delay alignment system setting new standards for audio performance and dramatically increasing phase response precision.
- - AC soft start circuitry with ON/OFF AC breaker switch provides thorough power protection.
- - Setup provides selection and control of different subwoofer combinations.
- - External Subwoofer output with independent internal and external Level control +/- 6dB.
- - High Frequency control +/- 3dB for precise adjustment.
- - Comprehensive front-to-back cooling system features chassis sealed pcb’s for improved reliability.
- - Line Driver ready - rear mounted Input impedance selector provides selection of
optimal input impedance when used with a KV2 Audio LD4 Line Driver. - - Individual signal inserts for Mid/High, Internal Subwoofer, and External Subwoofer signal paths
providing flexibility for insertion of signal processing or feeding from auxiliary sources as required. - - Includes all speaker cables for a single stack ES system.
High Frequency Amplifier Spec. |
|
Type | Class AB Push-Pull low inter-modulation Mosfet |
design with transformer balanced output | |
Rated Continuous Power | 100W |
Distortion | <0.05% |
Operating Bandwidth | 2.5kHz - 28kHz |
Mid Frequency Amplifier Spec. |
|
Type | Class AB Push-Pull low inter-modulation Mosfet |
design with transformer balanced output | |
Rated Continuous Power | 200W |
Distortion | <0.05% |
Operating Bandwidth | 500Hz - 2.5kHz |
Mid-Bass Frequency Amplifier Spec. |
|
Type | High efficiency, Low frequency, Current-enhancing |
Rated Continuous Power | 600W |
Distortion | <0.05% |
Operating Bandwidth | 130Hz - 500Hz |
Low Frequency Amplifier Spec. |
|
Type | High efficiency, Low frequency, Current-enhancing |
Rated Continuous Power | 1600W |
Distortion | <0.05% |
Operating Bandwidth | 20Hz - 130Hz |
Signal Input |
|
Input Sensitivity | 1.0V RMS |
Input Impedance | 20kΩ or 50Ω "Line Driver ready" |
Speaker Input |
|
Speaker Input | - / EP6 (Mid-Hi), EP4 (Sub) |
Power |
|
Power Connector | Neutrik PowerCon® |
Operating Voltage Range | 100-120V@60Hz | 205-240V@50Hz | 225-260V@50Hz |