Brands
EPAK 2500 AMPLIFIER
EPAK 2500 - Control of Your ES System
- - Four-way, active control and amplification unit specifically designed for the ES Series modular loudspeaker system
- - Houses all signal processing and four individual amplifiers and controls the allocation of power depending on the number of bass modules employed
- - Road-rugged eclosure, Baltic birch cabinet with built in cable storage compartment
- - Suspension system
- - Passive heat sink along with two demand-sensitive fans for added reliability
- - Active Driven concept with optional Super Digital 20MHz digital delay line
Features
- - 4-way modular, 2500W Control and Amplification system for use specifically
with ES Series modules. - - High Frequency, 100W, Class AB, push-pull, low intermodulation amplifier
with transformer balanced outputs. - - Mid Frequency, 200W, Class AB, push-pull, low intermodulation amplifier with
transformer balanced outputs. - - Mid Bass, 600W, high efficiency, current enhancing, switching amplifier.
- - Subwoofer, 1600W, high efficiency, current enhancing, switching amplifier.
- - Complete, on board speaker management system including equalization, time alignment,
crossover filters, amplifier overdrive protection, system set-up and output level controls. - - AC soft start circuitry with ON/OFF AC breaker switch provides thorough power protection.
- - Passive heat dissipation design with demand-sensitive forced cooling back-up system.
- - Setup provides selection and control of different subwoofer combinations.
- - Professional enclosure using exterior-grade Baltic birch with wear resistant polymer coating.
- - Removable front cover provides storage of all AC and speaker cables.
- - Bass Character- Attack or extension switch alters the low frequency character.
- - Includes all speaker cables for a single stack ES system.
High Frequency Amplifier Spec. |
|
Type | Class AB Push-Pull low inter-modulation Mosfet |
design with transformer balanced output | |
Rated Continuous Power | 100W |
Distortion | <0.05% |
Operating Bandwidth | 2.5kHz - 28kHz |
Mid Frequency Amplifier Spec. |
|
Type | Class AB Push-Pull low inter-modulation Mosfet |
design with transformer balanced output | |
Rated Continuous Power | 200W |
Distortion | <0.05% |
Operating Bandwidth | 500Hz - 2.5kHz |
Mid-Bass Frequency Amplifier Spec. |
|
Type | High efficiency, Low frequency, Current-enhancing |
Rated Continuous Power | 600W |
Distortion | <0.05% |
Operating Bandwidth | 130Hz - 500Hz |
Low Frequency Amplifier Spec. |
|
Type | High efficiency, Low frequency, Current-enhancing |
Rated Continuous Power | 1600W |
Distortion | <0.05% |
Operating Bandwidth | 20Hz - 130Hz |
Signal Input |
|
Input Sensitivity | 1.0V RMS |
Input Impedance | 20kΩ or 50Ω "Line Driver ready" |
Speaker Input |
|
Speaker Input | - / EP6 (Mid-Hi), EP4 (Sub) |
Power |
|
Power Connector | Neutrik PowerCon® |
Operating Voltage Range | 100-120V@60Hz | 205-240V@50Hz | 225-260V@50Hz |